Configuring Rip Route Control - H3C S5800 Series Configuration Manual

To do...
Specify a global RIP version
Return to system view
Enter interface view
Specify a RIP version for the
interface

Configuring RIP Route Control

In complex networks, you need to configure advanced RIP features.
This section covers the following topics:
Configuring an Additional Routing Metric
Configuring RIPv2 Route Summarization
Disabling Host Route Reception
Advertising a Default Route
Configuring Inbound/Outbound Route Filtering
Configuring a Preference for RIP
Configuring RIP Route Redistribution
Before configuring RIP route control feature, complete the following tasks:
Configure an IP address for each interface, and make sure all neighboring routers are reachable
to each other.
Use the command...
version { 1 | 2 }
quit
interface interface-type
interface-number
rip version { 1 | 2 [ broadcast |
multicast ] }
3-9
Remarks
Optional
By default, if an interface has a
RIP version specified, the version
takes precedence over the global
one. If no RIP version is specified
for an interface, the interface can
send RIPv1 broadcasts, and
receive RIPv1 broadcasts,
unicasts, RIPv2 broadcasts,
multicasts and unicasts.
—
––
Optional
By default, if an interface has no
RIP version specified, the global
version takes effect. If no global
RIP version is specified, the
interface can send RIPv1
broadcasts, and receive RIPv1
broadcasts, unicasts, RIPv2
broadcasts, multicasts and
unicasts.