Accommodating To The Types And Condition Of Media; Expanding The Printing Area By Reducing The Margins - Roland VersaUV LEJ-640 F User Manual

Expanding the Printing Area by Reducing the Margins

Procedure
Press .
MENU
SUB MENU
SUB MENU
SIDE MARGIN
SIDE MARGIN
10mm 5mm
A type of media is
displayed.
Press .
MENU
SUB MENU
Description
The "SIDE MARGIN" setting determines the distance from the left or right media clamp to the corresponding
left or right edge of the printing area. You can select "5 mm (3/16 inch)," "10 mm (6/16 inch)," or "25 mm (16/16
inch)." Setting this to "5 mm (3/16 inch)" lets you expand the printing area.
Note, however, that when you're using transparent media, setting this to "5 mm (3/16 inch)" may result in
printing on top of the media clamps.
The "FRONT MARGIN" setting determines the distance from the front edge of the rigid media to the printing
area. You can select "5 mm (3/16 inch)," "10 mm (6/16 inch)," or "25 mm (16/16 inch)." Setting this to "5 mm
(3/16 inch)" lets you expand the printing area.

Accommodating to the Types and Condition of Media

Press several times until the screen shown on
the left appears.
Press .
Press several times until the screen shown on
the left appears.
Press .
Press
Press to enable the setting.
When "SHEET SETUP" is set to any value other than "RIGID," the screen
shown on the left appears and setting is complete.
When "SHEET SETUP" is set to "RIGID," proceed to the next step.
Press several times until the screen shown on
the left appears.
Press .
Press several times until the screen shown on
the left appears.
Press .
Press
Press to enable the setting.
Only available when "SETUP SHEET" is set to "RIGID".
to select "5 mm (3/16 inch)."
to select "25 mm (16/16 inch)."
4
79