Getting Ready To Receive Data From A Computer - Roland Soljet EJ-640 User Manual

Outputting

Press
CLEANING...
>>>>>
NORMAL CL.
2
AB

Press

Perform a printing test again to make sure the dot drop-out has been corrected.
If the problem persists, try performing cleaning again. If the printer has been used for a long period, the
problem may not be fixed even after performing cleaning two or three times. If the problem doesn't go
away, try cleaning using a different method.
 P. 56, "When Normal Cleaning Is Not Effective"
When You Want to Clean All Print Heads Simultaneously
Hold down

Getting Ready to Receive Data from a Computer

When P. 26, "Loading Sheet Media" and P. 32, "Setup of Media" are completed, get the machine ready to
receive the data from a computer.
CAUTION
Procedure

Close the front cover.

Check that
If it is not lit, lower the loading lever and press

Wait until
42
.
The screen shown in the figure appears, and then cleaning starts.
01:45
The remaining process time (estimated) is displayed on the screen.
("01:45" = "1 minute and 45 seconds")
When cleaning finishes, the screen shown in the figure appears again.
, then to go back to the original screen.
for one second or longer. Cleaning for all print heads starts automatically.
Never touch the print heads while output is in progress.
The print heads move at high speed. Coming into contact with them may
cause injury.
is lit.
stops flashing and stays lit.
.