Installation & Communications - FingerTec TA100C User Manual

6 • INSTALLATION & COMMUNICATIONS
This Chapter is meant for qualified installer only. The installation of terminal shall be handled by a well-trained installer. If you are not a qualified
installer, you can ignore this Chapter or this Chapter serves as reference for all types of connections available for the terminal only.
CONNECTIONS avaILaBLE
TA100C Series
1 2
1. TCP/iP POrT
This port is for connection in LAN environment. A straight RJ45/CAT.
5E cable should be plugged here to connect to a network switch/hub.
A crossover RJ45 cable is for direct connection to a PC's network port.
2. uSB POrT
To upload/download user information, password, fingerprint and trans-
action logs via USB flash disk.
3. rS232/rS485 POrT
The port is for connection of RS232/RS485 communication type.
RS232 is a serial communication cable connecting from this port at one
end to a serial port of a PC at another end.
RS485 cable extender should be connected to this port and the other
of the cable should be connected to an optional RS232/RS485 Data
Converter before it can be connected to the serial port of a PC.
4. POwEr ADAPTEr POrT
This port is for the power connection. Plug the power adapter here.
58 CONTENTS
Q2i/TA200 Plus
3 4
Back of TA200 Plus
1. ACCESS COnTrOL COnnECTiOn
To link reader with door lock systems and alarm system.
4 5
2. COmmuniCATiOn COnnECTiOn
TCP/IP Connection to provide TCP/IP communication to computer via LAN cable.
RS232 Connection to provide RS232 communication to computer via RS232
cable.
RS485 Single Connection to provide RS485 communication to computer via
RS485 cable.
RS485 Network Connection to provide RS485 communication to computer via
RS485 network.
3. POwEr SuPPLy COnnECTiOn
To provide DC 12V to reader to operate.
4. TCP/iP POrT
TCP/IP port to provide TCP/IP communication to the computer via LAN cable.
5. DC12v pOWER
DC12V power input to provide power to the terminal.
2
Back of Q2i Connector Port
1
3