Manual Addressing - Lindab FDS-M User Manual

Press and use
OK
ADRESSMODE from NO to YES
Automatic addresmode
Address Mode: NO
Automatic addresmode
Address Mode: YES
Inside each slave unit connected to the system, press
the RIGHT BUTTON: units will be assigned the first
free address.
Back to the display on master unit.
Press and use
OK
ADRESSMODE from YES to NO
Automatic addresmode
Address Mode: YES
Automatic addresmode
Address Mode: NO
22
and to move
OK
OK
and to move
OK
OK

6.5.3 Manual addressing

Manual addressing mode means that number of damper
and its IP address are manually assigned to the user
by pressing buttons in the FDS-S as described below.
Go to the ADDRESSING display on master unit.
Addressing
Automatic
Manual
Add single detector
Choose unit
Unit: 1-60
Unit: 1-60
Ser.no:
Activate?YES
Confirm?--
Inside each slave unit connected to the system keep
LEFT BUTTON pressed to edit address and use UP/
DOWN/RIGHT BUTTONS to set the new address.
2018-08-01
-->
OK
OK