Blackberry R6020GW Installation And Getting Started Manual page 30

30 Getting started — Charging your handheld
To charge your handheld
Before using your handheld, and whenever your handheld's battery is low, follow
this procedure to charge the battery.
1. Insert your handheld in the cradle by aligning the connector port on the
bottom edge of your handheld with the connector prongs of the cradle. Press
your handheld firmly in place, as shown in the following illustration.
Note
2. Allow your handheld to charge to full battery power before using it. When
your handheld is charging, the battery power indicator (on the top right corner
of the Home screen) will change to a charging indicator. After your handheld
is fully charged, the battery power indicator will replace the charging
indicator.
Follow the procedure described above to recharge your handheld's battery when
necessary. Your handheld can be kept at a full charge by "topping up" the battery
every day for 10 to 15 minutes. From an empty battery, a full charge can be
achieved in approximately three to four hours. It is not necessary to drain the
battery completely before recharging it.
Note
To remove the handheld from the cradle
To remove your handheld from the cradle, brace the bottom of the cradle with one
hand and gently pull the handheld up and out of the cradle with the other hand.
Installation and Getting Started Guide
When you first receive your handheld and charge it, the handheld will turn on
and the Home screen will appear, displaying the handheld's function icons.
If the handheld's battery becomes too low, the level displayed by the battery
power indicator will also be low. The message Low Battery appears to the
left of the wireless coverage indicator and the handheld will beep. Recharge
your handheld as soon as possible.