Table of Contents
Advertisement
Adash Ltd.
A4300 - VA3 - Balancing
For instance we have a fan with the blades difference 15 deg. It means we can install mass to the
position 0 deg, ± 15 deg, ± 30 deg, ± 45 deg, ... Required position lies between -15 deg and -30 deg.
We enter these values to split weight screen. After both angles definitions the result masses are
calculated.
Clear meas. memory Item
This item will remove all measurements results and to begin balancing process again, it means from
st
1
RUN.
The balancing process can be interrupted in any step. It is possible to return (PgUp) back to any
measurement screen and by using START button run the measurement and continue balancing from
this position.
When you need to start the process again it is possible:
st
- run the measurement on the 1
RUN screen
- select Clear meas. memory item.
The Clear meas. memory removes only results of measurement. Information saved in the project is
not removed. When you need to remove current balancing project, you need to use Erase project.
New project Item
When you select this item then all data of the balancing memory will be erased. In the data memory
there is saved always a copy of balancing project, it means there is no danger of losing data. On the
next screen you have to set the parameters of new balancing project. Select individually items by
up/down arrows and confirm by right arrow, ENTER or START button. By using Save button you
can save the analyser setup to the setup memory of instrument.
Before definition of new project there is suitable to make several measurements in Analyser mode,
which help you to set parameters well:
- measure the machine speed in the condition which will be used for balancing.
13
Adash Ltd., Czech Republic, Tel.: +420 59 6232670, Fax: +420 59 6232671, e-mail: info@adash.cz
For further technical and contact information consult www.adash.net, www.adash.cz
Advertisement
Table of Contents
