Table of Contents
Advertisement
Adash Ltd.
- if you press ENTER instead of START then you can manually enter the values from keypad
(balancing calculator). Attention! You have to always enter the amplitude as RMS value. It will be
immediately re-calculated (test it).
Two different screens exist for:
- single plane balancing,
- dual plane balancing.
Single plane balancing
Balancing process in the single plane consists of the following steps:
st
- 1
RUN measurement
- entering of TRIAL MASS value and installation of trial mass to machine
nd
- 2
RUN and RESULT calculation
- removing of trial mass and installation of result mass
- running TEST MEAS. and calculation TRIM #1 result
- installation Trim #1 mass
- repeating of TEST MEASUREMENT and installation of next TRIM #2, #3 ... masses.
st
1
RUN
Push START button. The result is amplitude/phase of unbalanced machine. The example measured
amplitude 1.131 mil 0-P represents 100% amplitude for next balancing process. Measurement was
made at 1200 RPM. This speed also represents 100% of next balancing process.
TRIAL MASS
Push PgDn button. A trial mass input dialog box will appear. Enter trial mass value and push ENTER
button. Install trial mass on the machine. You can install it to any angle you want.
The example trial mass is 0.75 oz.
nd
2
RUN
The second run screen appears after the trial mass value has been entered. Use START button and
run the measurement. If the trial mass is installed in the wrong place (the measured phase is almost
the same as in the first run) then you are informed about it. Remove the trial mass and install it again
in different place (90° change is recommended) or enlarge its weight. Repeat the measurement.
Adash Ltd., Czech Republic, Tel.: +420 59 6232670, Fax: +420 59 6232671, e-mail: info@adash.cz
For further technical and contact information consult www.adash.net, www.adash.cz
8
A4300 - VA3 - Balancing
Advertisement
Table of Contents
