Toro Micro-Master Series User Manual page 63

Micro-Master Touch User Guide
Station Parameters
Station Name
Each Station can be assigned a name. Names are limited to 20 characters.
Station Water budget
The Water Budget for this Station.
Station Day Table
The Day Table, Start Times, and Cycle Count for this Station. If a PreStart Delay is specified, the
Start Time is the starting time of the PreStart Delay.
Station runtime
The runtime for this Station.
Use Station 1 Config
This option sets the Station to use the same configuration units as Station 1. When enabled,
changing the parameters in this Station will change the parameters for all Stations with this option
enabled.
Irrigation Units
Station programs can use irrigation units of hours:minutes, minutes:seconds, or volumetric. If
volumetric, the units are the same as the allocated Flow Meter.
Next Program
When a Station program completes, it is possible to automatically start another Station or Irrigation
Program. This allows staggered program starts.
PreStart Delay
A PreStart Delay starts the allocated Pump Set before the Station operates. This provides time for
pumps to pressurise lines if necessary.
Start Sensor
An allocated Start Sensor will start the Station program when the sensor is closed or triggered. A
Start Sensor could be a Switch Input, Digital Input, Analogue Input, Flow Meter or Rule. If the Start
Sensor is closed or triggered when a Station program completes, the program will immediately
recommence.
Stop Sensor
An allocated Stop Sensor will stop the Station program when the sensor is closed or triggered. A
Reset Sensor could be a Switch Input, Digital Input, Analogue Input, Flow Meter or Rule. The Stop
Sensor stops the Station program at any stage of the Station program.
Hold Sensor
An allocated Hold Sensor will pause the Station program when the sensor is closed or triggered. A
Hold Sensor could be a Switch Input, Digital Input, Analogue Input, Flow Meter or Rule.
© 2014 Toro Australia Pty Ltd 55 Ver 1.2, June 2014