Program Mode And Units - Toro Micro-Master Series User Manual

Micro-Master Touch User Guide
9.2.6

Program Mode and Units

The Program Mode and Units screen is the first page of Advanced Program Parameters and is
displayed by pressing the icon on the Program Edit - Sequential or Program Edit - Grouping
screen.
Figure 29 - Program Advanced Parameters Edit - Page 1
In the example screen shown in Figure 29, the Circulation program is operating in Grouping mode,
with time units of hours and minutes. When this program finishes, no other program will be started.
This program is not using the configuration of Program #1. By default, all programs use the same
configuration as Program #1, as this will be the most common situation. Parameters shared with
Program #1 are indicated by the * next to the parameter. For flexibility, individual programs can use
their own configuration.
Use Program 1 Config
When ticked, this program will share parameters from Program #1. Parameters shared with Program
#1 are shown with an asterisk following the name.
When changed from a tick to a cross, the shared parameters from Program #1 are copied into this
program. When this parameter is ticked, changes to a shared parameter are saved in Program #1.
By default, this option is enabled, therefore all programs share parameters with Program #1. Any
changes to shared parameters will affect all programs.
Program Mode
The program mode for this program. Selecting the button and clicking Edit will change the mode
between Grouping and Sequential.
Irrigation Units
The units of irrigation for this program. Selecting the button and clicking Edit will cycle the Irrigation
© 2014 Toro Australia Pty Ltd 49 Ver 1.2, June 2014