Storing The At30; Reporting Shipping Damage; Unpacking And Inspecting The At30; Inspection Checklist - HindlePower AT30 SERIES Operating And Service Instructions

RECEIVING THE AT30
1. RECEIVING THE AT30

1.1. STORING THE AT30

If you store the AT30 for more than a few days before installation, store it
the original shipping container, and in a temperature controlled, dry
climate. Ambient temperatures of 0 to 122 °F / -18 to 50 °C are
acceptable. Storage should not exceed two (2) years due to the limited
shelf life of the dc filter capacitors when they are not in service.

1.2. REPORTING SHIPPING DAMAGE

Upon delivery of the AT30 (or related products) if you discover any
damage or shortage, make notation on all copies of delivering carrier's
delivery receipt before signing and notify the delivery person of your
findings. If loss or damage is discovered after delivery, notify delivering
carrier immediately and request an inspection. The manufacturer does not
assume any liability for damage during transportation or handling.
Should the products require an inspection by (or return to) the
manufacturer, please contact your sales representative for further
instructions. Any returned material must be properly packed in
compliance with shipping regulations. It is preferable to use the original
shipping materials if possible. Mark the outside of the shipping container
with the Return Material Authorization (RMA) number issued by the
manufacturer.

1.3. UNPACKING AND INSPECTING THE AT30

Carefully remove all shipping materials from the AT30. Remove the
AT30 from the shipping pallet for inspection. Save all shipping materials
until you are sure that there is no shipping damage.
Once the AT30 is unpacked, inspect the unit for possible shipping
damage, using the checklist below. If shipping damage has occurred,
refer to Section 1.2 on this page for proper reporting.

INSPECTION CHECKLIST

Enclosure exterior and interior are not marred or dented.
There is no visible damage to exterior or interior components.
All internal components are secure.
Printed circuit boards are firmly seated on their standoffs.
All hardware is tight.
All wire terminations are secure.
The User's Manual and Quick Setup Sheet are supplied.
You received all items on the packing list.
2