Appendix B: Field Installable Accessories - HindlePower AT30 SERIES Operating And Service Instructions

Microprocessor-controlled three phase input float battery charger
Table of Contents

Advertisement

FIELD INSTALLABLE ACCESSORIES AND OPTIONS
All options and accessories listed below are available in kits for field
installation. Kits contain all parts and hardware with detailed installation
instructions. To order accessories/options, please provide the following
information for each kit:
• Model number, enclosure style, and serial number of your AT30
• Factory part number and description, from the table below
• Quantity required
Contact your sales representative to place an order for options & accessories.
standard DC Output Filtering (per NEMA PE5-1996)
Battery Eliminator Filtering (per NEMA PE5-1996)
Auxiliary Alarm Relay PC Board (A5) option
Copper Ground Bus with one (1) CU-AL compression box lug
AC Input Lightning Arrestor (VR3) option
Wall-Mounting Kit for Style-5018 Enclosure
Relay Rack-Mtg. Kit for Style-5018 Enclosure (23-24in/584-610mm)
NEMA Type 2 Drip Shield for Style-5018, -5030, -163 Enclosure
Cabinet Heater Strips for Style-5018 Enclosure
Cabinet Heater Strips for Style-5030 Enclosure
Cabinet Heater Strips for Style-163 Enclosure
Padlock for Style-5018, -5030, -163 Enclosure Front Panel Door
Remote Temperature Compensation Probe Assembly (EJ5033-##)
DNP3 Level 2 / Modbus Communications Module
Forced Load Sharing Accessory
Remote Temperature Compensation Probe
Full Option Part Number
(includes cable & probe)
EJ5033-00
EJ5033-01
EJ5033-02
EJ5033-03
The remote battery temperature compensation option is supplied as a bagged kit,
consisting of a single probe and user-specified cable. Also supplied are Installation
Instructions for the option and a special Application Note, see Section 1.11.
1. Use a single cable assembly. Do not try to splice cables together to increase the
length. If you need a longer cable, order a replacement from the table above.
2. To order a replacement probe (or puck), request part number
probe (A10) is good for all AT30 output voltages and all battery types.
Description
Cable Length
25ft / 7.6m
50ft / 15.2m
100ft / 30.5m
200ft / 61.0m
APPENDIX B
Kit Part Number
contact sales representative
contact sales representative
EI0213-02, -03, -04
EI0195-02, -03, -03
EJ1074-02
EI5008-00
EI0193-03
EI0191-02, -03, -04
EJ5042-00
EJ5166-00
EJ5183-00
EI0215-01, -01, -02
see table below
see Appendix E
EJ5126-##
Replacement Cable
Part Number
EJ5011-00
EJ5011-01
EJ5011-02
EJ5011-03
EJ5032-00
. This
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents