Mounting The At30; Floor-Mounting The At30 - HindlePower AT30 SERIES Operating And Service Instructions

INSTALLING THE AT30

1.5. MOUNTING THE AT30

The AT30 must be installed in manner that allows easy access to the front
ac (CB1) and dc (CB2) circuit breakers. Chose a mounting method for the
AT30 enclosure from the table below.
MANUAL
MOUNTING METHOD
SECTION
1.5.1
1.5.2
1.5.3
23-24in / 584-610mm

1.5.1. Floor-Mounting the AT30

Floor-mounting is the standard means of installing all the AT30
enclosures. When floor-mounting the AT30, consider the following:
1. Refer to the outline drawings in Appendix C, starting on page 66, for the
overall footprint of the Style-5018, Style-5030, and Style-163 enclosures.
2. Be conscious of planned ac input and dc output wiring to the AT30,
selecting conduit entrances carefully. Note the standard pre-fab conduit
knockouts located on the sides (and sometimes tops) of the enclosures.
3. The location:
• Should be free of drips and splatter. If falling particles and liquids are a
problem, install NEMA-2 type drip shield accessory (EI0191-0#). For
kit availability, see ordering information in Appendix B on page 65.
• Should be between 0 and 122 °F / -18 and 50 °C, with relative humidity
between 5% and 95% non-condensing.
• Must be free of flammable or explosive materials.
4. Maintain at least 6in / 152mm of free air on all vented surfaces for cooling.
5. Allow at least 36in / 914mm front clearance for access to the AT30 for
operation and maintenance.
PROCEDURE (Style-5018)
1. Install four (4) 0.25in / 6.4mm anchor bolts into the floor, per the mounting
dimensions featured in the outline drawing (JE5085-00).
2. Carefully lift the AT30 above the anchor bolts using the methods described
in Section 1.4. Guide the enclosure onto the floor bolt pattern and lower it
into place.
3. Add appropriate mounting hardware onto the floor-mounting anchor bolts
and tighten securely.
4
Floor-Mounting
Wall-Mounting
19in / 483mm
Rack-Mounting
Rack-Mounting
ENCLOSURE
Style-5018 Style-5030/163/198
STANDARD STANDARD
OPTIONAL
n/a
OPTIONAL
n/a
n/a
n/a