Setting The High And Low Dc Voltage Alarms - HindlePower AT30 SERIES Operating And Service Instructions

Setting the High DC Voltage Alarm
• Press the
EDIT/ENTER
flashes, and the display flashes the present value of the high dc voltage
alarm.
Press and release the
the display by one count, or press and hold the
the value in the display upward or downward. When the meter displays
the desired high dc voltage alarm point, release the
go past the voltage you want, press the
voltage you want to set.
• Press the
EDIT/ENTER
entered into permanent memory.
Setting the Low DC Voltage Alarm
• Press the
EDIT/ENTER
flashes, and the display flashes the present value of the low dc voltage
alarm.
Press and release the
the display by one count, or press and hold the
the value in the display upward or downward. When the meter displays
the desired low dc voltage alarm point, release the
go past the voltage you want, press the
voltage you want to set.
• Press the
EDIT/ENTER
entered into permanent memory.
If you want to adjust the Current Limit setting, skip to Section 2.3.5.
OR
If you want to exit the Edit Mode now, press the
return the AT30 to normal operation.
key until the HIGH DC VOLTAGE indicator
or key to increase or decrease the value in
UP DOWN
UP
key. The new high dc voltage alarm setting is
key until the LOW DC VOLTAGE indicator
or key to increase or decrease the value in
UP DOWN
UP
key. The new low dc voltage alarm setting is
OPERATING THE AT30
or key to scroll
UP DOWN
or
UP DOWN
or key again to reach the
DOWN
or key to scroll
UP DOWN
or
UP DOWN
or key again to reach the
DOWN
EDIT/ENTER
key. If you
key. If you
key again to
33