Table of Contents
Advertisement
Warning! Installing this lightening protection element between
an antenna and a BAT54-F does not alone provide sufficient
protection against a lightening strike. The BAT Surge Arrestor
lightening protection element only works as part of a compre-
hensive lightening protection concept. If you have any questions
relating to this, contact a qualified dealer.
Note: The requirements of EN61000-4-5, surge test on power supply
lines, are only met if a Blitzductor VT AD 24V, article No. 918 402, is used.
Manufacturer: DEHN+SÖHNE GmbH+Co.KG, Hans Dehn Str.1,
Postfach 1640, D-92306 Neumarkt.
Warning! Connect the external antenna, the access point radio interface
and the lightening protection to the same ground system, e.g. to the build-
ing ground.
2.2.4
Mounting/connecting external antennas
The BAT54-F devices have four connections for connecting external anten-
nas (AUX 1 / AUX 2, Main 1 / Main 2). These connections are N sockets.
The housing of the N socket and the signal connection are electrically con-
nected to the switching ground, the function ground and the metal housing of
the device.
On delivery, the connections are sealed with cover caps.
Main 2
AUX2
Main 1
AUX1
Unscrew the cover caps from the connections to which you want to con-
nect external antennas.
Connect the external antenna to the corresponding 'Antenna Main' con-
nection.
If you only want to connect one antenna with only one connection for each
radio module, you use the main connection.
Use the respective main connection of the two WLAN modules to connect
antennas with only one antenna connection without diversity.
BAT54-F
Release
12/07
23
Advertisement
Table of Contents
