Mounting The Housing Cover - Hirschmann BAT54-F Series User Manual

2.2.9

Mounting the housing cover

For use in environments with the danger of explosions, the BAT54-F X2 and
BAT54-F X2 FCC device models have an additional housing cover made of
stainless sheet steel.
On delivery, the housing cover is pre-mounted.
Perform the installation in the following steps:
Remove the upper part of the housing cover on the device, as shown in
the following figure (point 1).
Do not try to remove the lower panel of the housing cover from the device.
Screw the device, including the lower panel of the housing cover, to the
mounting surface.
Set up the connections to the device.
Close the housing cover by replacing the upper part of the housing cover.
Fasten the housing cover with four screws, as shown in the following fig-
ure (point 2).
1.
Figure 7: Mounting the housing cover for BAT54-F X2 device models with Ex certifi-
cation in accordance with ATEX 95 (ATEX 100a)
28
2.
Release
BAT54-F
12/07