Startup; Finding And Configuring Devices; Display Elements - Hirschmann BAT54-F Series User Manual

2.3

Startup

By connecting the voltage supply via the 5-pin M12 connector or via the LAN
cable (Power over Ethernet), you start the operation of the device.
After the device performs a short self-test, the power LED lights up green per-
manently or flashes alternately red and green if no configuration password
has been set yet.
2.4

Finding and configuring devices

Note: Always switch on the device before starting the computer for the con-
figuration.
A router or access point can be configured in the following ways (if the model
is equipped with the corresponding interface),
see the "Dual-Band Industrial Access Point / Access Client / Access Bridge
BAT54-Rail" user manual:
Via the local network (LAN). Via the radio network (WLAN), if the WLAN
encryption (e.g. WEP) in a device with a wireless interface and in the con-
figuration computer is set or deactivated respectively. Via the serial con-
figuration interface.
2.5

Display elements

After the operating voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, the LEDs
light up. The process takes around 60 seconds.
BAT54-F
Release 12/07
29