Nexo GEO M1210 System Manual page 61

GEO M12 HARDWARE SETUP PROCEDURE
Subsequent GEO M12s
- Lift assembly to sufficient height in order to connect a second GEO M12;
- Position second GEO M12 cabinet with AutoRig
first GEO M12
- Unlock GEO M12 link bar
- Pull the latch to engage the guide in GEO M12 rear slot.
- Adjust the angle by inserting quick release pin BL820 in proper hole.
- Connect subsequent GEO M12 cabinets as with second.
Ensure that bumper quick release pins are properly locked into GEO M12, and that all
AutoRig
- Lift cluster to NS-1 defined rigging height, secure cluster horizontally to prevent it from rotating;
- Secure bumper with secondary safety steel.
The requirements for secondary safety systems vary with territories. However, the
secondary safety steel MUST have a SWL equivalent or greater than that of the rigging
system.
Disassembly
- While holding GEO M12 to be dismounted, pull AutoRigTM on both sides and hold the side knob
(AutoRigTM remains in the open position).
- Remove the rear quick release pin BL820
- Unlock the GEO M12 link bar by pulling the latch.
- Remove GEO M12
TM
in automatic lock position, and lock front points to
IMPORTANT
TM
and rear connecting points are locked
IMPORTANT
Page 61/90