Table of Contents
Advertisement
Page 48/90
-
If required, connect GMT-EXBARM12L to GMT-LBUMPM12 by inserting GMT-EXBARM12L clevis
pins into GMT-LBUMPM12 "B" and "F" holes
-
Insert shackle(s) in bumper or in extension in required hole(s) as indicated in NS1 design and secure
shackle bolt(s);
"A" to "G" on GMT-LBUMPM12
o
Or "H" to "Q" if using GMT-EXBARM12L
o
o
If using 2 hoists, connect these using extreme points
("A" and "G", or "H" and "Q")
-
Connect hoist hook(s) to shackle(s) and lift assembly to sufficient height in order to connect a second
GEO M12
Ensure hoist hook(s) is (are) properly secured to GMT-LBUMPM12 or GMT-EXBARM12L
Subsequent GEO M12s
-
Position second GEO M12 cabinet with AutoRig
first GEO M12
-
Unlock GEO M12 link bar
-
Pull the latch to engage the guide in GEO M12 rear slot.
-
Adjust the angle by inserting quick release pin BL820 in proper hole.
-
Connect subsequent GEO M12 cabinets as with second.
GEO M12 HARDWARE SETUP PROCEDURE
IMPORTANT
Ensure that all quick release pins are locked
TM
in automatic lock position, and lock front points to
Hide quick links:
Advertisement
Table of Contents
