Table of Contents
Advertisement
GEO M12 HARDWARE SETUP PROCEDURE
Maximum GEO M12 quantity for flown vertical cluster with GMT-LBUMPM12 is 12 (and
eventually less).
Please check NS-1 for mechanical Safety Working Load and acoustic computations.
Motor hoist must be rated to support entire cluster weight. Please check configuration
Procedure
GMT-LBUMPM12 can be flipped front and back depending if its connects to GEO M12 Right or Left.
When connecting GEO M12 Left, bumper front is on the "A" hole index side
-
When connection GEO M12 Right, bumper front is on the "G" hole index side
-
GEO M12 Left
-
Position first GEO M12 so that Autorig
Position bumper ("A" hole at front) on top of first GEO M12
-
-
Remove the two BL820 quick release pins from their side storage position, and the BL825 quick
release pin of rear bumper link bar.
-
Connect bumper front points to GEO M12 with the BL820 quick release pins
Connect the bumper link bar (0° position) to GEO M12 rear rigging plate (hole marked "bumper") Lock
-
with the quick release pin BL0825.
GEO M12 Right
-
Position GEO M12 so that Autorig
Position bumper ("G" hole at front) on top of first GEO M12
-
-
Remove the the BL825 quick release pin of rear bumper link bar.
-
Connect bumper front points to GEO M12, front points will lock automatically
Connect the bumper link bar (0° position) to GEO M12 rear rigging plate (hole marked "bumper") Lock
-
with the quick release pin BL0825.
IMPORTANT
IMPORTANT
in NS-1 for proper motor hoist rating
TM
is at the bottom
TM
is at the top and set in automatic lock position
Page 47/90
Hide quick links:
Advertisement
Table of Contents
