Table of Contents
Advertisement
Page 60/90
-
Once all MSUB18 are off the ground, position second VNT-BUMPM12 below last MSUB18
-
Pull bottom bumper front latches, and rotate the upper links so that single leg, and release the
latches
-
Unlock last MSUB18 top front and rear rigging points
-
Connect bottom bumper to last MSUB18 by locking front and rear rigging points
GEO M12 Left
-
Position first GEO M12 below bottom bumper so that Autorig
-
Pull the bottom bumper front latches, rotate the lower links so that connection points are double leg
and release the latches.
-
Position first GEO M12 below bottom bumper and lock front points to the bumper with 2 BL820 quick
release pins.
-
Connect the bumper link bar at required angle (selection from -12° to +12° in 3° steps) to GEO M12
rear rigging plate (hole marked "bumper") and lock with the quick release pin BL0825.
GEO M12 Right
-
Position first GEO M12 so that Autorig
-
Pull the bumper front latches, rotate the lower links so that connection points are single leg and
release the latches.
-
Position bumper on top of first GEO M12, front points will lock automatically
-
Connect the bumper link bar at required angle (selection from -12° to +12° in 3° steps) to GEO M12
rear rigging plate (hole marked "bumper"), and lock with the quick release pin BL0825.
GEO M12 HARDWARE SETUP PROCEDURE
TM
is at the top and set in automatic lock position
TM
is at the bottom
Hide quick links:
Advertisement
Table of Contents
