Table of Contents
Advertisement
Page 58/90
Required items
-
1 or 2 hoists (not provided).
-
2 x VNT-BUMPM12
-
1 x VNT-EXBARM12 for extended positive and negative bumper angles
When flying MSUB18 & GEO M12 cluster, VNT-BUMPM12 must be set at 0°
-
If cluster is flown from 2 points, bumper must be maintained horizontal in its definitive
position as well as when lifting or lowering the cluster
-
If cluster is flown from a single point, extension bar must be used and hoist connected
to "G" position
Maximum quantity for flown vertical cluster with VNT-BUMPM12 is:
Please check NS-1 for mechanical Safety Working Load and acoustic computations.
Motor hoist must be rated to support entire cluster weight. Please check configuration
Procedure
-
Position first MSUB18 and unlock front and rear rigging points
-
Pull the bumper front latches, rotate the lower links so that connection points are double leg and
release the latches.
-
Position bumper on top of first MSUB18 and lock front and rear points to the bumper with 2 BL820
quick release pins.
-
If flying with bumper only, pull front and rear center latches, and release front and rear bumper
connecting points.
GEO M12 HARDWARE SETUP PROCEDURE
IMPORTANT
IMPORTANT
N
+ 1.5*N
GEOM12
IMPORTANT
in NS-1 for proper motor hoist rating
<= 12
MSUB18
Hide quick links:
Advertisement
Table of Contents
