Geo M12 Only On Lightweight Bumper - Nexo GEO M1210 System Manual

Page 32/90

6.3.2 GEO M12 only on Lightweight Bumper

Required item
- 1 x GMT-LBUMPM12
GMT-LBUMPM12 is rated for a maximum of 3 stacked GEO M12 in any inter cabinet
angle configuration with 0/+3° initial angle, provided the stack is assembled according
to below rules:
- GMT-LBUMPM12 must always be installed on a horizontal surface
- Public is not allowed within a safety area which radius is equal or higher than assembly
height.
Procedure
GMT-LBUMPM12 can be flipped front and back depending if it connects to GEO M12 Right or Left.
When connecting GEO M12 Left, bumper front is on the "G" hole index side
-
When connection GEO M12 Right, bumper front is on the "A" hole index side
-
GEO M12 Left
Set the bumper on the ground so that front is on the "G" hole side
-
- Remove the BL825 quick release pin of rear GMT-LBUMPM12 link bar, and rotate it upwards
- Release first GEO M12 link bar, and set AutoRig in automatic lock position
- Position first GEO M12 on top of the bumper, front points will lock automatically
- Connect the bumper link bar (selection of 0° / +3°) to GEO M12 rear rigging plate (hole marked
"bumper") Lock with the quick release pin BL0825.
GEO M12 HARDWARE SETUP PROCEDURE
IMPORTANT
IMPORTANT
Ensure that all AutoRig
TM
systems are locked