Dmx Mode; Dmx Configuration; Wireless Setting - ProLights GALLERYCLIPSETU User Manual

GALLERYECLIPSETU - GALLERYECLIPSEDY

3.4 DMX MODE

• Press the button MENU so many times until the display shows DMX ADDRESS, and press the button ENTER
to confirm.
• Press UP/DOWN button to select the desired value (001-512). Press and hold to scroll quickly.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
To able to operate the GALLERYECLIPSETU-DY/TRWD with a light controller, adjust the DMX start address
for the first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function
of the first DMX channel, adjust the start address 33 on the GALLERYECLIPSETU-DY/TRWD. The other
functions of the light effect panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:

3.5 DMX CONFIGURATION

GALLERYECLIPSETU-DY/TRWD is equipped with different DMX configuration.
• Press the button MENU so many times until shows DMX CHANNEL, and press the button ENTER to confirm.
• Select the desired DMX configuration (1CH - 3CH ) through the buttons UP/DOWN.
The tables on page 16 indicate the operating mode and DMX value.

3.6 WIRELESS SETTING

To set the wireless mode refer to the following guide:
• Press the MENU button until the display shows Wireless Setting, then press the ENTER button.
• Use the UP/DOWN button until the display reads Wireless Receive, and then press the ENTER button
and select the ON mode.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE - After you complete these steps, you have to synchronize with any wifi unit with which you want
to communicate by pressing the sync button present on the same. Then connect any DMX console to wifi
unit for to open the communication with the GALLERYECLIPSETU-DY/TRWD unit.
• To reset the unit press the MENU button until the display shows Reset Connect, then press the ENTER
button.
• Use the UP/DOWN button until the display reads Yes, and then press the ENTER button.
Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Number of
Start address
DMX
(example)
channels
3 33
DMX Address Next possible start
occupied address for unit No. 1
33-35
DMX512 Controller
Next possible start
address for unit No. 2
36
wireless
solution
Next possible start
address for unit No. 3
39
9
42
Fig.6