Making A Recording - Extron electronics RCP 101 EU Setup Manual

RCP 101 EU and RCP 101 MK • Setup Guide (Continued)
To save a recording to the USB device inserted into the RCP 101, click
3.
Recording Media Selection
and
Recording
From the
RCP USB
appropriate, select
1 1
3 3
5 5
SMP Web Page
Figure 10.
To configure Front Panel Lockout, click
4.
The options shown in
Front Panel Lockout (Executive Mode) is disabled (see
•
Beep when button is pressed
•
Beep when alarm is triggered
•
Select or deselect the appropriate checkbox to enable or disable those options.
Firmware
The firmware version installed on the RCP 101 must be compatible with the firmware installed on the SMP. To ensure this, the
RCP 101 firmware is managed automatically by the SMP series products. The firmware version of the RCP 101 can be found on
the SMP embedded web page under
When the remote control panel is first connected to the SMP, the SMP checks the firmware version on the RCP 101 and, if
necessary, automatically updates the panel firmware to a compatible version.
If you update the SMP firmware, the RCP 101 firmware is automatically updated at the same time. For more information about
updating SMP firmware, see the SMP User Guide at www.extron.com.

Making a Recording

Once the SMP and RCP 101 are installed, and configured, follow these instructions to make a recording using the RCP 101:
Open the SMP web page to ensure the recording will be saved to the correct drive and that the USB drive, if required, is
1.
attached to the correct drive.
Start the recording by pressing the
2.
If required, add a chapter marking by pressing the
3.
If required, pause the recording by pressing the
4.
Restart the recording by pressing the
End the recording by pressing the
5.
For more information, see the SMP User Guide at www.extron.com.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics,
see the Extron Safety and Regulatory Compliance Guide
6
4
( ).
Destination drop-down menu, or the
.
4 4
Configuration
figure 9 (see previous page) are available only when the RCP 101 is detected. By default:
is enabled.
is disabled.
Configuration > System Settings > Unit Identification
Record
button
Mark
Pause
Pause
button a second time or by pressing the
End
button (figure 1,
© 2016 - 2018 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Configuration
Secondary Recording Destination
2 2
1 System Settings
( ),
Front Panel Lockout (Executive Mode)
(figure 1, A , on page 1).
button (figure 1, E ).
button (figure 1, D ).
C
).
on the Extron website.
www.extron.com
System Settings
( 1 ),
drop-down menu, as
2 Executive Mode
( ), and
on page 2).
.
Record
button.
68-3000-51 Rev. B
( 2 ),
5
( ).
10 18