CARE AND MAINTENANCE
SPECIFICATION
4. Remove the wire mesh and filter pad
from the exhaust module.
5.
Clean the filter pad or replace it with a
new one , place filter pad back into the
exhaust module .
6.
Secure the filter pad by fitting the wire
mesh on top of the filter pad.
Replace the exhaust module back into
7.
the main unit attach the fan guard and exhaust module securely
with screws A, B , C and D
(fig. 1 page 13).
Replacing the Fan
1.
Follow steps 13 of "replacing/cleaning the filter pad"
2.
Remove Screws E, F, G, and H as shown.
E
G
H
F
14
3.
Detach the fan's power connec
tor from the main unit (note: the bot
tom chassis may need to be removed
to reach the fan's other wire see " re
placing the heating element guide for
detaching bottom part").
4.
Pull out the Fan.
5.
Attach the new fan's power
wires to the main unit.
6.
Insert the fan back into the main
unit. Reattach Screws E,F,G,H.
7.
Reinsert the exhaust module
back into the main unit and attach the
fan guard and exhaust module se
curely with screws A, B , C and D
page 13).
II Working with the solder pot
A. For dip soldering printed circuit boards:
Prepare the PCB to be soldered. Insert all thru hole compo
●
nents into the printed circuit board.
Use a tong to hold the PCB and briefly dip the underside of
●
the PCB into the solder pot.
Smoke generated from the process will then be quickly filtered
●
thru the filter pad.
Continue dip soldering PCBs.
●
When all the PCB are soldered. Turn off the smoke absorption
●
switch and then switch off the main power.
B. For tinning solder tips, stranded wires and pretinning
small electrical parts:
Prepare the items to be tinned. Ensure items are clean and
●
free from unwanted dirt or oil.
Use tweezers or pliers to hold small components and briefly
●
dip the tip of the components into the solder pot.
Smoke generated from the process will then be quickly filtered
●
thru the filter pad.
Continue tinning items.
●
When all the work is finished. Turn off the smoke absorption
●
switch and then switch off the main power.
WARNING:
eral hours after usage, extreme caution should be followed when
handling for storage or placement.
(fig.1
OPERATING GUIDELINES
Aoyue 936 规格
Aoyue 936 规格
Contents of the solder pot can still be very hot for sev‐
11