Control Panel Guide - aoyue SP2000 Instruction Manual

CARE AND MAINTENANCE
3. Loosen screw on the grid connector to detach the heater wires.
Note:
Detach the two heater wires, and temperature sensor
connector located at the back of the control board.
4.
Heater Wires
5.
Loosen
Temperature sensor connector
Heater Wires
screw
M
N
Grounding plate
P
Pulling up top part to
expose the crucible
clamp and heat resis‐
tant pad.
Heat resistant
16
Remove screws M , N , O , P,
and the earth grounding plate at the
center of the crucible. Then care­
fully pull out the crucible.
The crucible together with the
heating element, thermal sensor
and crucible dock would come out
in one piece, leaving the heat resis­
tant pads inside the chassis.
Removing screw M,N,O,P and
Grounding Plate
Crucible w/Heating
element
O
pads
CONTROL PANEL GUIDE
焊铁头的维护和使用
Aoyue 936 规格
SP2000
Solder pot
LEGEND:
1 — Digital temperature display
2 — Temperature Adjustment knob
3 — Smoke absorption switch
4 — Main power switch
IMPORTANT REMINDERS:
1.Make sure the equipment is placed on a flat stable heat re­
sistant surface.
2.Ensure all function switches are OFF prior to plugging in.
3.Ensure all terminal connections are properly secured.
9