Operating Guidelines; Menu Structure - aoyue INT9378 Instruction Manual

OPERATING GUIDELINES

6. To save the settings, repeatedly press the SET button until the
display shows the word "SAVE". Press the decrease button to save
and exit from the system configuration mode.
7. The two quick jump settings has now been configured and can be
accessed by simultaneously pressing the "INCREASE" and "SET"
button for the first Quick jump level. And simultaneously pressing
the "DECREASE" and "SET" button will access the second quick
jump level.
Quick Jump #1
b350 (default)
Increase + Set
E. SLEEP FUNCTION
The Soldering Iron is equipped with a vibration sensor. When the
soldering iron has been left unmoved the system would begin the count
down of the sleep timer. The suffix will change to a small letter "d" to
indicate that the system is preparing to enter sleep mode. The display
will show four dashes "- - - - " to indicate the system has entered sleep
mode. To wake the system, simply lift up the soldering iron or push
any control buttons.
Sleep timer is configurable via the following method:
1. With the unit turned On, Press and hold the SET button to enter the
system configuration mode.
2. Repeatedly press the "SET" button until a number with prefix "t" or
"t000" is displayed. This denotes that we are now configuring the
sleep timer setting.
10
Quick Jump #2
C430 (default)
Set + Decrease
OPERATING GUIDELINES
REMINDERS:
Make sure the equipment is placed on a flat stable surface and all
◆
the heat-generating components placed on their respective holders
or stands.
Ensure all function switches are in the OFF position.
◆
Ensure all terminal connections are properly secured.
◆
IMPORTANT: Please refer to the CONTROL PANEL
GUIDE page for buttons and display
panel directory.

Menu Structure:

Current tool detected.
Digital offset value (-70 to +70).
Quick Jump Settings 1 (200– 480).
Quick Jump Settings 2 (200– 480).
Sleep timer currently set to 60 minutes (0-60 minutes).
Lock out feature.
Centigrade or Fahrenheit selection
Power LED for LED tool .
Save settings and exit.
Do not save settings and exit.
7