L-Series Integrated Speed Control
Alarm / Shutdown Tab
The Alarm/Shutdown tab provides alarm and shutdown configuration settings.
Figure 6-9. Configuration Editor—Alarm/Shutdown Tab
Alarm / Shutdown Fault Settings
Fault Selection (Shutdown or Alarm)
Set the desired action for each of the faults from the list. Setting the
selection to a Shutdown will position the output to the configured Fault
Direction (see Overview tab). Setting the selection to an Alarm will allow the
unit to attempt to continue running. For details on each of these fault
conditions, refer to the Fault section in the manual (Chapter 4).
•
Temperature Sensor Failed
•
Supply Voltage Fault
•
Relay Fault
•
Over Temperature
•
Position Error
•
Governor Error High Speed
•
Governor Error Low Speed
•
At Minimum Fuel Limit (5418-2193 software only)
80
Manual 26250
Woodward