Table of Contents
Advertisement
8.
Press in injector with installation/removal jig.
9.
Remove installation/removal jig.
10.
Coat screw head mating face and thread of
hold-down clamp (2) with engine oil.
11.
Fit hold-down clamp (1) in correct position, fit
screw (2) and tighten by hand.
Note:
Make sure parts are perfectly clean.
12.
Apply engine oil to thread, sealing taper and
thrust ring of adapter (3).
13.
Apply (Assembly compound (Kluthe Haku-
form 30-15)) to O-rings on adapter (3).
14.
Install adapter (3) and tighten hand-tight.
15.
Use a torque wrench to tighten hold-down clamp screw (2) to specified tightening torque.
Name
Screw
16.
Use a torque wrench and long socket to tighten adapter (3) to specified tightening torque.
Name
Adapter
Note:
Make sure parts are perfectly clean.
17.
Coat thread and sealing cone of HP line (5) with engine oil.
18.
Thread in HP line (5), ensuring that the sealing areas are not damage.
19.
Tighten nuts (4, 6) by hand as far as possible.
20.
Use a torque wrench to tighten nuts (4, 6) to specified tightening torque in the following order. Tightening
sequence:
1 Nut on adapter (4)
2 Nut on rail (6)
Name
Nut
254 | Injector | MS15038/01E 2018-11
Size
Type
M12
Tightening torque
Size
Type
Tightening torque
Size
Type
Tightening torque
Lubricant
Value/Standard
(Engine oil)
100 Nm+10 Nm
Lubricant
Value/Standard
(Engine oil)
100 Nm+10 Nm
Lubricant
Value/Standard
(Engine oil)
45 Nm +3 Nm
Advertisement
Table of Contents
