Table of Contents
Advertisement
Note:
Remove plugs on HP line only before installa-
tion of the adapter.
2.
Remove plug.
3.
Use milling cutter to remove oil carbon from
sealing face on cylinder head and protective
sleeve.
4.
Coat damper ring (2) with (Assembly com-
pound (Molykote P 37)).
5.
Coat O-rings (3) and (5) with (Assembly com-
pound (Kluthe Hakuform 30-15)).
Note:
Make sure that the sealing ring does not fall
into the water sleeve.
6.
Ensure that the sealing ring (4) is correctly
seated.
7.
Insert injector (1) in the cylinder head, ensur-
ing that it is correctly aligned with the HP line
connection.
8.
Press in injector with installation/removal jig.
9.
Remove the installation/removal jig.
10.
Coat screw head mating face and thread of
hold-down clamp (2) with engine oil.
11.
Fit hold-down clamp (1) in correct position, fit
screw (2) and tighten by hand.
Note:
Make sure parts are perfectly clean.
12.
Apply engine oil to thread, sealing taper and
thrust ring of adapter (3).
13.
Apply (Assembly compound (Kluthe Haku-
form 30-15)) to O-rings on adapter (3).
14.
Install adapter (3) and tighten hand-tight.
248 | Injector | MS15038/01E 2018-11
Advertisement
Table of Contents
