Adjustment
13
Manual cutting control
.08.06
Fit the needle plate.
Manually move the thread catcher 1 to its front turning point.
Pull a double-up length of thread and hook it in the thread catcher cutout.
Carry out the cutting operation manually.
If the threads are not cut according to the rule, align the thread catcher 1 (screws 2) to
If the threads are not cut according to the rule, align the thread catcher 1 (screws 2) to
Move the stop 4 until it abuts the thread catcher 1 and tighten the screws 5.
Check chapter 13.08.03 Aligning the thread catcher laterally and adjust if necessary.
104
Rule
Two threads must be cut cleanly on both the left and right in the thread catcher cutout 1.
on the -25/01
1
2
4
3
Fig. 13 - 15
the knife 3 accordingly (not on the -25/01).
the knife in the needle plate accordingly (on the -25/01).
5
2
4
1
2
5
5
1