E l e c t r o n i c S u b a s s e m b l y R e m o v a l
If the hood cover has been damaged, remove the hood cover for easier access to the electronic subassembly. Install a new cover after the service is
complete.
Fold the hood cover forward and remove the SRAM eTap AXS Blips or
1
seal plugs from the electronic subassembly.
Remove the screw from the auxiliary connector cover, then fold the
2
hood cover backward.
Hold the pivot pin nut in place, then unthread the pivot pin bolt from
3
the hood assembly.
For best performance, make sure the pivot pin bushings remain on the
pivot pin nut and bolt.
T6
2.5 mm
Electronic Subassembly Removal
2.5 mm
24