Hose Installation - SRAM eTap AXS Service Manual

H o s e I n s t a l l a t i o n
Internally routed frames: Insert the hose and route it through the
1
frame or fork.
Externally routed frames: Loosely connect the hose to the frame or
fork.
Apply a thin layer of grease to the banjo bolt o-rings, then install the
2
banjo bolt into the new banjo.
Install the new banjo onto the caliper.
3
To shorten the hose, hold the hose up to the shift-brake lever with a
4
length that creates a gentle bend in the hose and allows the handlebar
to freely turn from side to side.
Mark your cut location, then cut the hose.
You must cut the hose at the lever. Cutting the hose at the caliper
will remove the crimped banjo from the hose, and it will need to be
replaced.
NOTI CE
DOT grease
T25 5 N·m (44 in-lb)
Hydraulic hose cutter
20

Hose Installation