nvent 910 Series Installation, Operating And Maintenance Instructions page 75

Other Alarms Configuration Sub-Menu
Parameter Factory
Lo Load Enable Lo Load
Hi Load Disable
Hi Load *n/a (30.0A)
Hi Load Filter *n/a (0 sec)
Hi GFI Enable
Hi GFI 20 mA
Hi GFI Filter 0 sec
GFI Trip Enable
GFI Trip 30 mA
Lo Volt Enable
Lo Volt 90 V
Lo Volt Filter 0 sec
Hi Volt Disable
Hi Volt *n/a (270V)
Hi Volt Filter *n/a (0 sec)
Lo Resist Disable
Lo Resist *n/a (50%)
Lo Resist Filter *n/a (0 sec)
Hi Resist Disable
Hi Resist *n/a (50%)
Hi Resist Filter *n/a (0 sec)
Nominal Resist *n/a (6.00 Ω)
Overcurrent Trip *n/a (Enable)
Switch Fail Enable
HTC Reset Disable
C.B. Limiting *n/a (Disable)
Power Limiting *n/a (Disable)
Switch Limiting *n/a (Disable)
Contactor Count Enable
Contactor Count 200,000
EEROM Data Fail Enable
User
1.0 A Lo Load Filter 0 sec
nVent.com | 75