nvent 910 Series Installation, Operating And Maintenance Instructions page 22

22 | nVent.com
CONTROL SETPOINT = 20°C
LO TS 1 = –10°C
LO LOAD = 1.0 A
HI GFI = 50 mA
GFI TRIP = 75 mA
TS ALARMS CONFIG...
OTHER ALARMS CONFIG...
POINT SETUP...
MISC SETUP...
COMMUNICATIONS SETUP...
---- END ----
Table 4.7 Other Alarms Configuration Sub-Menu
LO LOAD
LO LOAD
LO LOAD FILTER
HI LOAD
HI LOAD
HI LOAD FILTER
HI GFI
HI GFI
HI GFI FILTER
GFI TRIP
GFI TRIP
LO VOLT
LO VOLT
LO VOLT FILTER
HI VOLT
HI VOLT
HI VOLT FILTER
LO RESIST
LO RESIST
LO RESIST FILTER
HI RESIST
HI RESIST
HI RESIST FILTER
NOMINAL RESIST
OVERCURRENT TRIP
SWITCH FAIL
HTC RESET
C.B. LIMITING
POWER LIMITING
SWITCH LIMITING
CONTACTOR COUNT
CONTACTOR COUNT
EEROM DATA FAIL
---- END ----
= {ENA or DIS}
= {0.3 to 100.0} A
= {0 to 12} S
= {ENA or DIS}
= {0.3 to 100.0} A
= {0 TO 12} S
= {ENA or DIS}
= {20 to 250} mA
= {0 to 12} S
= {ENA or DIS}
= {20 to 250} mA
= {ENA or DIS}
= {10 to 330} V
= {0 to 12} S
= {ENA or DIS}
= {10 to 330} V
= {0 to 12} S
= {ENA or DIS}
= {1 to 100} %
= {0 to 12} S
= {ENA or DIS}
= {1 To 250} %
= {0 to 12) S
= {2.00 to 2000.00} (only if LO or HI is enabled)
= {ENA or DIS} (only if SSR is being used)
= {ENA or DIS}
= {ENA or DIS}
= {ENA or DIS} (only if SSR is being used)
= {ENA or DIS} (only if SSR is being used)
= {ENA or DIS} (only if SSR is being used)
= {ENA or DIS} (only if Deadband or Prop Amb
Contactor are being used)
= {0 to 999999} (only if Deadband or Prop Amb
Contactor are being used)
= {ENA or DIS}