nvent 910 Series Installation, Operating And Maintenance Instructions page 25

4.3.7 "COMMUNICATIONS SETUP..." SUB-MENU
The settings found in this sub-menu must be configured whenever an optional
communications board is installed in the Control Module.
CONTROL SETPOINT = 20C
LO TS 1 = –10C
LO LOAD = 1.0 A
HI GFI = 50 mA
GFI TRIP = 75 mA
TS ALARMS CONFIG...
OTHER ALARMS CONFIG...
POINT SETUP...
MISC SETUP...
COMMUNICATIONS SETUP...
---- END ----
Table 4.10 Communications Setup
PROTOCOL
HTCBUS ADDR
MODBUS ADDR
MODBUS SUB ADDR
BAUD RATE
PARITY
HARDWARE
DRIVER
PROFILE
Tx DELAY
---- END ----
= {HTCBUS or MODBUS ASCII
or MODBUS RTU}
= {1 to 16777215}
= {1 to 247}
= {0 to 31}
= {AUTO or 9600 or 4800
or 2400 or 1200 or
600 or 300}
= {NONE or ODD or EVEN}
= {NONE OR MODEM OR
RS-232 or RS-485}
= {AUTO or RS-485 or
RS-232 or MODEM}
= {AUTO or 3-WIRE RS-232
or RS-485 or 1200 BAUD
MODEM or 300 BAUD
MODEM}
= {0.00 to 2.50} S
(only if PROTOCOL=HTCBUS)
(only if PROTOCOLHTCBUS)
(only if PROTOCOLHTCBUS)
(only if PROTOCOLHTCBUS)
nVent.com | 25