nvent 910 Series Installation, Operating And Maintenance Instructions page 23

4.3.5 "POINT SETUP..." SUB-MENU
The "Point Setup" sub-menu is used to configure parameters that relate directly to the specific
control point. Included in this menu are control mode settings, circuit breaker and switch
ratings, autocycle set-up parameters, etc.
4.3.5 "POINT SETUP..." SUB-MENU
The "Point Setup" sub-menu is used to configure parameters that relate directly to the specific
control point. Included in this menu are control mode settings, circuit breaker and switch
ratings, autocycle set-up parameters, etc.
CONTROL SETPOINT = 20°C
LO TS 1 = –10°C
LO LOAD = 1.0 A
HI GFI = 50 mA
GFI TRIP = 75 mA
TS ALARMS CONFIG...
OTHER ALARMS CONFIG...
POINT SETUP...
MISC SETUP...
COMMUNICATIONS SETUP...
---- END ----
Table 4.8 Point Setup Sub-Menu
TAG
SWITCH CONTROL MODE
DEADBAND
PROP BAND
CYCLE TIME
SWITCH RATING
CIRCUIT BREAKER
MAX POWER
TS FAIL MODE
TS CTL MODE
TS 1 TYPE
TS 1 LEAD RESIST
TS 1 HI LIMIT
TS 2 TYPE
TS 2 LEAD RESIST
TS 2 HI LIMIT
AUTO-CYCLE
AUTO-CYCLE INTERVAL
AUTO-CYCLE UNITS
OVERRIDE SOURCE
LOAD SHEDDING
---- END ----
= {19 ALPHANUMERIC CHARACTERS}
= {PROPORTIONAL, PROP AMB SSR, DEADBAND, or
PROP AMB CONTACTOR}
= {1 to 50}°C (only if SWITCH CONTROL MODE
is DEADBAND)
= {1 to 50}°C (only if SWITCH CONTROL MODE
is not DEADBAND)
= {10 to 255} MIN (only if SWITCH CONTROL MODE
is not PROP AMB CONTACTOR)
= {0.3 to 100.0} A (only if SSR is being used)
= {0.3 to 100.00} A (only if SSR is being used)
= {3 W to 33,000} W (only if SSR is being used)
= {OFF or ON}
= {TS 1-FAIL OFF (ON) or
TS 1-FAIL TO TS 2 or
TS 2-FAIL OFF (ON) or
TS 2-FAIL TO TS 1 or
AVERAGE-FAIL OFF (ON) or
AVERAGE-FAIL TO GOOD or
LOWEST-FAIL OFF (ON) or
LOWEST-FAIL TO GOOD}
= {100 W PLAT or NI-FE}
= {1 to 20.000}
= {ENA or DIS}
= {100 W PLAT or NI-FE}
= {0 TO 20.000}
= {ENA or DIS}
= {ENA or DIS}
= {1 to 240}
= {HOURS or MINUTES}
= {REMOTE or EXT INPUT}
= {ENA or DIS}
(only if TS 1 TYPE = NI-FE)
(only if TS 2 TYPE = NI-FE)
(only if AUTO-CYCLE=ENA)
(only if AUTO-CYCLE=ENA)
nVent.com | 23