General Legal Information - SINTERIT Lisa User Manual

2) FLEXA → PA12 SMOOTH
● When changing Flexa to PA12 it is required to clean the device very precisely.
Special attention should be paid on the bottom and side walls of the Print Bedt and
the Source Bed as well as the Recoater's guide bar. It is also recommended to clean
the area around the Beds using compressed air. Disassemble the Recoater's casing
and remove the remaining powder. It is important to clean the printer as thoroughly as
possible before adding PA12; otherwise, the remaining Flexa (with its properties
similar to rubber, becoming liquid in temperatures above 100[°C]) may get into the
mechanism responsible for moving the Beds or the Recoater's mechanism, and
damage the device.
● Clean the laser protection glass as some fumes may release during printing with
Flexa and make the glass foggy. If it is hard to clean the surface, you can use ethyl
acetate.
14. General legal information
Where this manual refers to Sinterit or the Company, this means Sinterit sp. z o.o. with its
legal seat in Krakow, registered by the District Court for Kraków-Śródmieście in Cracow, XI
Commercial Division of the National Court Register under number: 535095, NIP (tax
number): 6793106416, with the share capital for a date of publication of this manual of PLN
78,350 (say: seventy eight thousand three hundred and fifty).
This document contains material protected under copyright and industrial property laws. This
means that the document may not be, including but not limited to, reproduced or modified
without the consent of Sinterit.
This manual serves to assist in the correct use of the device, perform basic maintenance
and, if necessary, to solve simple problems, allowing to maintain the device in a good
condition.
This manual contains content exclusively for the provision of information and the use by
individuals professionally trained and engaged in the operation and maintenance of the
equipment described below.
The information contained in this document is intended for use only with the product made by
Sinterit and called Sinterit Lisa.
Due to the constant development of Sinterit's products the information contained in this
manual, specifications and markings are subject to change without notice.
74
​
Sinterit Lisa USER MANUAL