SINTERIT Lisa User Manual page 57

10. Remove any remaining powder from the Source. This can be done with the use of a
spatula or by moving the Source Bed to the top (MECHANICS//SOURCE//▲) and
moving the powder to the Overflow Bin using a spatula. Transfer the powder to the
container with the powder from the Overflow Bin.
STOP!
Do not use any greases or oils for the guide bar of the Recoater. This may
cause damages to the device.
For cleaning, it is recommended to use a paintbrush with a soft bristle
(included in the set), or compressed air (when there is no powder inside
the printer).
11. Check if all elements are at their default positions (Recoater, laser).
12. Check the tension and condition of the Recoater wire.
56
Image. Removing the remaining powder from the inside of the printer.
​
Sinterit Lisa USER MANUAL