Printing In Advanced Mode: Automated Version - SINTERIT Lisa User Manual

2. In order to open the printer, release the blockade from the magnetic lock on the lid
(press PRINT//UNLOCK LID on the screen).
3. Softly press and then lift the lid. Remember that the lock is unlocked for 10 seconds.
4. Verify whether the Source Bed and Print Bed are ready to work (during the initial
startup, after unpacking, the Beds should be on par with the printer's case), check the
wire tension and whether the guide bar for the Recoater is clean (should be located in
the middle, in between the Beds).
5. Disassemble the Recoater cover and wipe the rotating shaft with a cotton cloth
soaked with alcohol.
6. The following stages may be carried out in two ways: manually and automatically
(recommended). Both processes have been described below in two subchapters.
A. Printing in ADVANCED MODE: automated version
1. Load the file for printing:
a. save the file prepared using the Sinterit Studio, to a USB carrier (USB flash
drive recommended),
b. connect the carrier to the USB port of the printer, with its power on,
c. in order to load a new file, select: PRINT//LOAD MODEL//LOAD FROM
USB//file name. The loading process may take a few minutes (depending on
the file size),
47
Image. Releasing the blockade from the lock.
​
Sinterit Lisa USER MANUAL