C Leaning Of Laser Protective Glass - SINTERIT Lisa User Manual

Close the lid and protect is by the metal clasp. Clean glass once more to get rid of any finger
marks or stains.
B. Cleaning the laser protection glass
ATTENTION!
Before cleaning, turn the printer off.
a. To clean the laser protective glass, ensure that you are holding the heating module by
one hand. Then pull out the clasp placed on the top of the inner part of the lid. By
lowering the heating module, you will get access to the laser protective glass socket.
b. To open the laser protective glass socket, you need to unscrew the wings on the right
side of it. While doing this, remember to hold the metal frame and then gently draw
out the socket. Now you can take the glass out of the frame, put it on a stable and
clean surface and start cleaning
c. To clean the laser protective glass, rub its surface carefully with a cotton cloth soaked
with alcohol (pay attention to any fibers left on the surface) and clean both sides of
the glass.
63
​
Sinterit Lisa USER MANUAL