Sinterit Studio Software - Installation - SINTERIT Lisa User Manual

In the following situations, unplug the product from the power supply and contact a qualified
service personnel:
1. the power cord or plug is damaged,
2. some liquid got into the product,
3. the product has been dropped or the case has been damaged;
4. the product does not operate properly or clear changes in efficiency have been
observed.
Do not adjust controls that are not described in the manual.
ATTENTION! ​ D o not:
ATTENTION! ​ I f the device is not used for a long time (e.g. vacation), unplug
the power cord from the socket.
5. Sinterit Studio software - installation
Technical requirements to install Software:
1. Connect the USB flash drive included in the set to the computer USB port.
2. Locate the Sinterit Studio folder.
3. Open SinteritStudioSetup.exe.
17
● Pay special attention to the fact that the power cables are not bent at
the points of connection of the printer.
● Disconnect the plug whenever it is planned to shift/transfer the device.
● spill liquid on the product;
● put any containers on the equipment, in particular containing water;
● handle it with wet hands;
● block or cover the vents and openings in the product;
● touch movable parts.
● Windows 7 or higher,
● Minimum 500 MB of disk space,
● Minimum 2 GB of RAM,
● Graphics adapter compatible with OpenGL 3.0 or higher.
​
Sinterit Lisa USER MANUAL