Installation In Hazardous Area - Siemens SITRANS MAG 6000 I Operating Instructions Manual

Safety notes

2.3 Installation in hazardous area

● Overvoltage category II
● Pollution degree 2
CE marked equipment
The CE-mark symbolizes the compliance of the device with the following directives:
● EMC-directive 2004/108/EC
● Low voltage directive 2006/95/EC
● Pressure equipment directive (PED/DGRL) 97/23/EC
● ATEX Directive 94/9/EG
2.3 Installation in hazardous area
Conditions for safe use
Equipment used in hazardous areas must be Ex-approved and marked accordingly. It is
required that the special conditions for safe use provided in the manual and in the Ex
certificate are followed!
Suitable hazardous area approval
Make sure the hazardous area approval is suitable for the environment in which the device
will be installed.
"Flameproof enclosure" type of protection
Only open devices with type of protection "Flameproof enclosure" in hazardous areas when
the power to the device is turned off, otherwise there is a risk of explosion.
12
NOTICE
Material compatibility
Siemens Flow Instruments can provide assistance with the selection of wetted sensor
parts. However, the full responsibility for the selection rests with the customer and Siemens
Flow Instruments can take no responsibility for any failure due to material incompatibility.
WARNING
WARNING
WARNING
SITRANS MAG 6000 I/6000 I Ex de
Operating Instructions, 08/2018, A5E02083319-AH