6.2 Start
The router will start when a power supply is connected to the router. By default, the router
will automatically start to log on to the default APN. The DHCP server will start to assign
addresses for devices connected through the Ethernet port ETH. These router behaviors can
be changed via the web interface. This is described in detail in the Configuration manual for
SmartStart.
6.3 Configuration
Attention! If no SIM card is inserted in the router, it is not possible for the router to
operate. Any inserted SIM card must have active data transmission.
6.3.1 Configuration by web browser
For status monitoring, configuration and administration of the router, a web interface is
available, which can be accessed by entering the IP address of the router into the web browser.
The default IP address of the router is 192.168.1.1. Attention, it is necessary to use HTTPS
protocol for secure communication over a network!
Figure 25: Entering the IP address of the router
By default, configuration can only be performed with the default username "root" and default
password "root".
Figure 26: Entering login information
26
SmartStart SL302