Start; Configuration; Configuration By Web Browser; Entering The Ip Address Of The Router - Advantech SmartFlex SR305 User Manual

6.2 Start

The router will start when a power supply is connected to the router. By default, the router
will automatically start to log on to the default APN. The DHCP server will start to assign
addresses for devices connected through the Ethernet port ETH0. Router's behavior can be
changed via the web interface. This is described in detail in the Configuration manual for
SmartFlex routers.
6.3 Configuration
If no SIM card is inserted in the router, it is not possible for the router to operate. Any
inserted SIM card must have active data transmission.
6.3.1 Configuration by web browser
For status monitoring, configuration and administration of the router a web interface is
available which can be accessed by entering the IP address of the router into the web browser.
The default IP address of the router is 192.168.1.1. Attention, it is necessary to use HTTPS
protocol for secure communication over a network!
Figure 50: Entering the IP address of the router
By default, configuration may be performed only by the user "root". The default password
is printed on the router's label.
All routers have the WebAccess/DMP client pre-installed by default. The activated client
periodically uploads router identifiers and configuration to the WebAccess/DMP server.
See the configuration manual [2], chapter Basic Information -> WebAccess/DMP Config-
uration, for more information.
After successfully entering login information, the user will have access to the router web
interface via their browser.
1
If the router's label does not contain a unique password, use the password "root".
1
Change the default password as soon as possible!
42
SmartFlex SR305