Removal From The Din Rail; Default Position Of Metal Din Rail Clip - Advantech SmartStart SL302 User Manual

SmartStart SL302

5.6 Removal from the DIN rail

The DIN rail clip is suitable for a DIN rail according to EN 60715 standard only. The default
position of metal rail clip, which is used for mounting the router on a DIN rail, is shown in the
following figure. When mounting the DIN rail clip, tighten the screws with max. 0.4 Nm torque.
Figure 13: Default position of metal DIN rail clip
To remove the router from the DIN rail, push the router down lightly, so the bottom part of
the DIN rail clip (hitched to the DIN rail) gets out of the rail and then pull out the bottom part of
the router away from the DIN rail.
Figure 14: Removal from the DIN rail
15