Start; Configuration; Configuration Over Web Browser; Entering The Ip Address Of The Router - Advantech LR77 v2 Libratum User Manual

6.2 Start

The router is put into operation when the power supply is connected to this router. By
default, the router will automatically start to log on to the default APN. DHCP server will start
to assign addresses for devices on the Ethernet port ETH0. Router's behavior can be changed
via the web interface. This is described in detail in the Configuration manual for v2 routers.
The power consumption during receiving is 2.3 W. The peak power consumption during
data sending is 5.5 W. However, values of consumption can be increased, if some expansion
port is eqquipped. For correct operation it is necessary that the power source is able to supply
a peak current of 1.2 A.

6.3 Configuration

If no SIM card is inserted in the router, it is not possible to operate. Inserted SIM card
must have activated data transmission.

6.3.1 Configuration over web browser

For status monitoring, configuration and administration of the router is available a web
interface which can be accessed by entering the IP address of the router into the web browser.
The default IP address of the router is 192.168.1.1.
Figure 26: Entering the IP address of the router
Configuration may be performed only by the user "root". The default password is printed
1
on the router's label. Change the default password as soon as possible!
All routers have the WebAccess/DMP client pre-installed by default. The activated client
periodically uploads router identifiers, configuration, and cellular network statistics to the
WebAccess/DMP server. See the configuration manual [2], chapter Basic Information ->
WebAccess/DMP Configuration, for more information.
After successfully entering login information user gains access to the router via his internet
browser.
A detailed description of the router settings via the Web interface can be found in the document
Configuration manual for v2 routers.
1
If the router's label does not contain a unique password, use the password "root".
LR77 v2 Libratum
21