Internal Cable Routing; 2.5-Inch Drive Models; Internal Faceplate Transition (Ift) Adapter - Lenovo 5468 Setup Manual

Thinksystem sd650 dual node dwc tray and nextscale n1200 dwc enclosure

Hide thumbs Also See for 5468:

Table of Contents

Power supply error LED (yellow): When this LED is lit (yellow), it indicates that there is a fault with the

power supply.

Note: Before unplugging the ac power cord from the power supply, or removing the power supply from the

enclosure, verify that the capacity of the remaining power supplies are sufficient to meet the minimum power

requirements for all components in the enclosure.

Internal cable routing

Some of the components in the solution have internal cables and cable connectors.

Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from

the system board. Failing to release them before removing the cables will damage the cable sockets on the

system board, which are fragile. Any damage to the cable sockets might require replacing the system board.

Some options, such as IFT processors, might require additional internal cabling. See the documentation that

is provided for the option to determine any additional cabling requirements and instructions.

The following illustrations show the cable routing for 2.5-inch drive models.

1x2.5-inch drive model

Figure 11. Cable routing - 1x2.5-inch drive model

2x2.5-inch drive model

Figure 12. Cable routing - 2x2.5-inch drive model

The following illustration shows the cable routing for the Internal Faceplate Transition (IFT) adapter.

Chapter 2

Solution components

Table of Contents

7x58