Figure 37. DIMM installation
Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly
inserted; open the retaining clips, remove the DIMM, and then reinsert it.
Step 6.
Reinstall the DIMM cover.
Figure 38. DIMM cover installation
After you install a DIMM, complete the following steps:
1. Reinstall the tray cover (see "Install the tray cover" on page 61).
2. Reinstall the tray (see "Install a DWC tray in the enclosure" on page 63).
3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate
both nodes are ready to be powered on.
Install an M.2 drive into the M.2 backplane
Use this information to install an M.2 drive in the M.2 backplane.
.
Chapter 3
Solution hardware setup
51